Second Gun And Hose Installation - Graco GM 5000 Instructions And Parts List

Second Gun and
Hose
inst
NOTE Fig. 5 represents the installation at Step 3.
6.
Disconnect the trigger cable from the second gun
NOTE: To switch the gun assemblies to the engine side
of the cart, refer to the instructions on page 18 before in-
7.
Unscrew the filter's second outlet cap (14). Screw
stalling the second gun kit. the short hose (403) onto the filter nipple.
1. Disengage the trigger cable from the block (48) of
8.
Remove the guide clamp screw (27).
at the screw (34). See Fig. 5, DETAIL
8.
the unit's existing gun. See page
22.
Engage the
gun's trigger safety latch. 9. Snap the cable bushing
(E)
into the guide plate (D).
2. Loosen the carriage clamps
(8,
C). Slide the car-
Route the trigger cable (402) parallel with the main
riage bar (4) off the cart. the cable through
it.
Install and tighten the clamp
gun cable, separating the guide clamp (104)
to feed
3. For mountina the secondgm bar on the oumD side
screw (27). Route the cable through the cable guide
pf the cart: Slide a clamp (405A) onto the carriage
(7)
and to the second gun.
bar (4). Slide the carriage bar through the pump- 10. Slide the hooked end of the cable (402) through the
cart. Now slide another clamp (4058) onto the car-
side carriage clamp (B) and into the center of the hole
(F)
in the lever plate (122). Rotate and slide the
riage bar. See Fig. 55.
hook back until
it
engages the plate. See DETAIL A.
For mountina the second aun bar on the enaing
11.
Reconnect the trigger cable
to
the second gun at
side of the cart: Follow Step 3, except slide the car-
screw (34). Torque the screw to 15 in-lb (I
. 7
Nm),
riage barthrough the engine-side carriage clamp
back
it
off 1/16
to 1/8 turn and then tighten the jam
(C) and the into the center of the cart. The knobs
o f
nut (99) while holding the screw (34). Be sure the
the clamps (405A, 4058) must face back toward the
plate (94) moves freely.
handle bars. 12. Install the clip (401) to hold the cable onto the frame.
5
'Iide the second gun bar (404) far enough into the 14. Do not install the spray tip until the system is primed.
carriage bar that the clamp (4058) engages the bar.
Position the clamps (4054 4058) Over the notches 15. Adjust simultaneous gun triggering. See page 19.
(A) in the carriage bar (4) and tighten the clamps.
NOTE: For stable gun operation, the second
extension from the carriage bar of about
gun bar (404) has a maximum recommended
11-'/4" (286
mm).
Torque to 15 In-lb
e157
12
308-105