Maintenance - Graco GM 5000 Instructions And Parts List

Maintenance
To reduce the risk of serious bodily injury always fol-
low
the Pressure Relief Procedure Warning on
page
4,
before checking, adjusting, cleaning or
shutting down the tine Lazer.
CAUTION
tions, refer
to
the separate HONDA engine manual.
For detailed engine maintenance and specifica-
Daily: Check the engine oil level and fill as necessary.
Dally: Check and fill the gas tank.
After the first 20 hours of operation and each 100
hours thereafter: Change the oil.
Weekly: Remove the air filter cover and clean the ele-
ment. In very dusty environments, check the filter daily.
Replace the element as needed. Replacement ele-
ments can be purchased from your local HONDA dealer.
Weekly: Check the level of the TSL in the displace-
ment pump packing nut. Fill the nut, if necessary. Keep
TSL in the nut to help lubricate the pump packings. See
page 10.
Weekly: Use a grease gun to grease the zerks (32) on
this unit. The grease purges pivot areas of paint buildup.
See Fig.
20.
Spark plug:
Use
only a (NGK) BPGES or
BPRGES
plug. Gap the plug to 0.025 to 0.030 in. (0.7 to 0.8 mm).
Always use a spark plug wrench.
A
One zerk on dual gun selector
A
One zek on each gun holder
A
One zerk on caster lwer
A
One zerk on caster
latch
A
One zerk on wheel
Fig.
308-105
23