Setup For Spraying Arcs; Adjust Simultaneous Gun Triggering - Graco GM 5000 Instructions And Parts List

Positioning
the
Gun Arm Asse
Setup
for Spraying Arcs
3. Extend the carriage bar (4) or second gun bar
(404)
1. Disengage the trigger cable (1) and engage the gun
so you can easily watch the line you are painting
and also to avoid running over the paint line.
See
page 18.
trigger safety latch.
See
page 22.
. -
Loosen the arm 'lamp
(SI
and rotate the arm (A)
4.
Adjust the vertical and horizontal position of the
back near the rear tire and then position the arm
so
the spray tip guard aligns with the back axle of the
unit. Retighten the clamp.
5.
Spray the arc from the outside.
gun.
Fig.
14
02155
Adjust Simultaneous Gun Triggering
WARNING
3. Start the sprayer, using water, or spray on card-
board. See page 14. Trigger the guns to see if the
lines begin at the same time and place.
e aun triaaers before the other
cable tension of the gun that triggers first. See Ad-
,
reduce the
just the trigger cable tension on page 22
ltpoe
line starts in front of the o t k adjust the posi-
1. Align the front of the guns by adjusting the gun
tion of the guns. See page 18.
Trigger the guns to recheck the adjustments.
arms. See page 18.
2. Position the dual gun selector to trigger both guns.
See page 21.
308-105
19