NOTE: A standard steering wheel puller is re-
4 in. long screws are also needed.
quired to remove the clamp. Two 1/4-28 x 3 or
NOTE: Refer to Fig. 42.
1. Loosen the
two screws
(60) on the clamp
of the clutch housing
(61).
(68).
working through the slot at the bottom
2. Install
two screws
(B)
of the tool (A) in two of
the threaded holes in the clamp. Tighten the
screws (C) until the clamp comes off.
3. Skip ahead to
Reassembly, page
38,
Step 3,
or continue below.
Fig.
42
Clutch .Housing
NOTE: Refer to Fig.
43.
1. Remove the four capscrews (8) and lock-
washers
(48)
which hold the clutch housing
(2) to the engine (1).
2.
Remove the engine key (13).
61
3. Pull off the clutch housing (2).
4.
Skip ahead to Reassembly, page
38,
15
157
Step 1.
A
Fig. 43
oou1
308-105
37