Starting Com247 - Siemens SIMATIC S5 Manual

Starling COM247
5.4

Starting COM247

The following description assumes that you have made the preparations described in "System
configuration" (you have created a system diskette or installed COM247 on the hard disk).
With PGs without a hard disk, the prepared system diskette is inserted in drive A and
the data diskette in drive B
With PGs with a hard disk, drive A: must not have a diskette inserted
Start the PG by turning on the power or using the keyswitch
The S5 call loads the KOMI in the user memory of the PG. While this is being loaded, the KOMI
mask appears as shown below:
S5 - Komi
Xxxx-yyyy-zzzzzz
Serial-No.:
Copyright (c) 1986
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
In the "SELECT PACKAGE" menu, you can now select the required program, in this case
program is loaded from mass memory. Once the package is loaded, the first COM247 display,
the configuration display, appears.
5 - 1 0
All rights reserved