Siemens SIMATIC S5 Manual page 75

or dwell time, this acts as "external stop"; the machining program is terminated. If, following the
completion of the traversing movement ("position reached" message set), a"1" is set at the digi-
tal input, the machining program is also interrupted. The message "FC1 (65) machining program
waiting to continue" is output. After "enter", the message "motor waiting for external start" ap-
pears. If the lP247 then detects a negative edge change, the statement is executed.
Example: N1 X1OO F2500 MOO
N2 X200 F1 000 M20
N2 .,..
Fig. 2/24 External start-stop
2-58