Entering Machining Programs In The Text Mode - Siemens SIMATIC S5 Manual

Analogous to <Fl >, this function key is used to page backwards.
With this key, you can switch to text representation.
This function key inserts a line in front of the current cursor position.
This function key deletes the line marked by the cursor.
If the machining program is syntactically correct, you save the program on the pre-
viously selected device under the specified DB number with this key. If the program al-
ready exists on this device and with this DB number, you will be asked whether or not
to overwrite the data block.
The machining program is printed out if you
as those for printing machine data (cf. Section 5.6.1.3 "Print Machine Data"), When ma-
chining programs are being printed out, "MACHINING PROGRAM DIN" is displayed in
the third output field of the header.
With the exit key, you exit the input function without saving the data.
5.6.2.4

Entering Machining Programs in the Text Mode

n the text mode, onlv one
I
function can be sele~ted using the HELP key <F7>. With the other functions, you must ente[
the appropriate numerical values.
— —
— — — — —-—
—
— —
Statement no.
F u n c t i o n 1 [ L ] : ~ '
Function 2
[xl :
Function 3
Function 4 [F] : ~ee~rate
F u n c t i o n 5
NEXT PREVIOUS
STATEMEN STATEMENT
Fig, 5/1 7 Machining program display in the text mode
statement is displayed on the screen. The
— —
M A C H I N I N G PROGR~M
— — — — —
Statement type : ~o"rw)
– —
Target :
— —
' ] 3s
. . .
:
INSERT DELETE
TEXT
= input field
press
this key. The displays are the same
tYPe of statement and the G
—
DEVICE : ~D
—
Dimensions
' J
— — — —
SAVE HELP
output
Input
—
-J
EXIT
field
5-39