Siemens SIMATIC S5 Manual page 166

Machine Data Page 4
Module :
—
Tool length offset
B a c k l a s h c o m p e n s a t i o n :
Zero offset 1
Zero offset 2
Zero offset 3
Zero offset 4
, : , , . . . . . : . : . : , . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PREVIOUS
NEXT
PAGE PAGE
Fig. 5/1 1 Machine data page 4
Description of the output fields
The header remains as described in section "Machine Data Compilation",
Module, axis, meas. system, axis type: see Machine Data Page 1.
Description of the input fields
Tool Ienoth offset;
corrected by this value. The length must be less than the range allowed by the software
limit switches. This correction is added to a tool length offset previously selected and can
be called repeatedly in machining programs.
Zero offset 1 ...4:
The values of the four zero offsets are independent of each other and can be called in-
dividually in machining programs. The range of values of the four offsets is L99999.999
mm and must not be exceeded.
Siemens AG°C79000-68576 -C707-01
DEVICE ~ IP247 J
J
Axis : ~ ~ Meas. s y s t e m : ~m~ Axis type:
— —
: : & . ;$~. nmm~ ~
. . — —
. . . . .
. . . . . . . . . . . . . . . . .
PRINT
B L O C K : DB lti3~
(+- 99999,S99)
(+- 99999.999)
99999,999)
. . . . . . . . .
EXIT
TRANSFER
Input
5 - 2 9