Sensor Setup] Tab - Furuno SC-33 Operator's Manual

2. HOW TO SETUP THE MENU
2.3

[Sensor Setup] Tab

Enter the ship's information and installation location of the SATELLITE COMPASS
the sensor offset values on the [Sensor Setup] tab.
Menu Item
Sensor Offset HDG
Roll
Pitch
SOG/3-Axis Speed
Air Pressure
Air Temperature
Dimensions/ Equipment Identification
CCRP
Ship's Width
Ship's Length
Ship's Height
ANT Position X0
ANT Position Y0
ANT Position Z0
Offset the heading angle. When the heading angle is
skewed right, enter a negative value. When the heading
angle is skewed left, enter a positive value,
Offset the roll angle.
Offset the pitch angle.
Not used. Reserved for future use.
Offset the air pressure value.
Offset the air temperature value.
Assign the equipment ID of the SATELLITE COM-
™
PASS . When multiple SATELLITE COMPASS
connected in the same NMEA2000 network, be sure to
assign a different equipment ID to each SATELLITE
™
COMPASS .
Note: The equipment ID is required to connect with the
PC (SC setting tool). When you change the equipment
ID, record the equipment ID information for each SATEL-
™
LITE COMPASS .
Set the ship's width.
Set the ship's length.
Set the ship's height.
Set the port-starboard (Lateral) location of the SATEL-
™
LITE COMPASS . Enter a negative value for port-side,
positive value for starboard-side. The center of the ves-
sel is "0 m".
Set the bow-stern (Longitudinal) location of the SATEL-
™
LITE COMPASS . Calculated from the center of the
bow.
Set the height of the SATELLITE COMPASS
bottom of the ship.
7
™
and adjust
Remarks
™
™
are
, from the