Sensor] Menu - Furuno SATELLITE COMPASS SC-33 Operator's Manual

Menu item
GLONASS1
GLONASS2
GLONASS3
Galileo All
Galileo1
Galileo2
Galileo3
SV ELEV
SV ELEV
SBAS
SBAS Mode
SBAS Search
SBAS Satellite Selection Manually input the SBAS satellite number(s) you want to use.
Disable SBAS All
SBAS
SBAS 1
SBAS 2
SBAS 3
QZSS
ON/OFF
3.2

[Sensor] Menu

Enter the ship's information and installation location of the SC-33 and adjust the sensor offset val-
ues on the [Sensor] menu.
Menu item
Offset
HDG Offset the heading angle. When the heading angle is skewed right, enter a
negative value. When the heading angle is skewed left, enter a positive value.
Pitch Offset the roll angle.
Roll Offset the pitch angle.
Air Pressure Offset the air pressure value.
You can ignore satellites of the GLONASS system by specifying the sat-
ellite number. A maximum of three satellites can be registered to be ig-
nored.
Note: When [GLONASS All] is set to [YES], the setting values for [GLON-
ASS1] to [GLONASS3] are automatically changed to "0".
Select [YES] to ignore all satellites of the Galileo system.
You can ignore satellites of the Galileo system by specifying the satellite
number. A maximum of three satellites can be registered to be ignored.
Note: When [Galileo All] is set to [YES], the setting values for [Galileo1]
to [Galileo3] are automatically changed to "0".
Adjust the elevation mask angle. This equipment does not track satellites
with an elevation angle lower than the angle set here. A higher elevation
mask angle increase the positioning accuracy, but the number of the
available satellites may be decreased and equipment may not be able to
obtain an accurate position fix
Enable/disable correction from SBAS (Satellite-based Augmentation
System).
• [On]: Enable correction from SBAS.
• [Off]: Disable correction from SBAS.
Select [Auto] to search automatically for SBAS satellites, or [Manual] to
manually input the SBAS satellite number.
Note 1: This item is only available when [SBAS Search] is set to [Manu-
al].
Note 2: A satellite number entered at [Disable SBAS] will be rejected.
Select [YES] to ignore all SBAS satellites.
You can ignore SBAS satellites by specifying the satellite number. A max-
imum of three satellites can be registered to be ignored.
Note: When [SBAS All] is set to [YES], the setting values for [SBAS 1] to
[SBAS 3] are automatically changed to "0".
Enable/disable the use of the QZSS system. Reboot the SC-33 to apply
the setting.
17
Description
Description
3. ADJUSTMENTS