Gnss Setup] Tab - Furuno SC-33 Operator's Manual

No. Name
5 [Apply All] button
6 [Disconnect] button
2.2

[GNSS Setup] Tab

You can disable (ignore) satellites and adjust the elevation mask from the [GNSS Setup] tab.
Menu Item
Disable SV GPS
GLONASS
Galileo
QZSS
SV ELEV
SBAS Mode
Search
Satellite Selection
Disable SBAS
Click this button to apply the settings on all tabs. The [Apply], [Apply
All] and [Disconnect] buttons are grayed out while applying the set-
tings.
Disconnect from the SATELLITE COMPASS
lect Device] dialog box.
You can ignore satellites by specifying the satellite number with
each positioning system (GPS, GLONASS, Galileo, QZSS). A
maximum of three satellites can be registered to be ignored.
When you check the [Disable All] checkbox, all satellites of se-
lected positioning system are ignored. In this case, the drop
down list for selecting the satellite number is grayed out.
Adjust the elevation mask angle. This equipment does not track
satellites with an elevation angle lower than the angle set here.
A higher elevation mask angle increases the positioning accura-
cy, but the number of the available satellites may be decreased
and the equipment may not be able to obtain an accurate posi-
tion fix.
Enable/disable correction from SBAS (Satellite-based Augmen-
tation System).
• [On]: Enable correction from SBAS.
• [Off]: Disable correction from SBAS.
Not used. Reserved for future use.
Not used. Reserved for future use.
Not used. Reserved for future use.
6
2. HOW TO SETUP THE MENU
Remarks
™
and go back to the [Se-
Remarks