2. HOW TO SETUP THE MENU
No.
Name
1
Select Antenna
2
Legend
3
Vibration Status
4
Satellite location
5
Elevation mask angle
6
Receiver signal level
Select the antenna number to show the satellite information ([Anten-
na 1] to [Antenna 4]).
Note: [Antenna 1] and [Antenna 2] are available for SC-33. However
you can select [Antenna 3] and [Antenna 4], the satellite information
is not displayed.
The legend of the satellite location for positioning:
• [No Use]: Not used for positioning.
• [Pos-Fix]: Used for positioning fix only.
• [Att & Pos Fix]: Used for attitude and positioning fix.
The vibration and impact test result (OK or NG). This test result indi-
cates that the installation location is appropriate or not.
Shows the available satellites and their elevation, which are detected
by the sensor selected at [Select Antenna]. When the satellite posi-
tion is overlapped, the satellite whose elevation angle is the most
highest is displayed on other satellite. The center of the circle indi-
cates the own ship position and elevation angle "90°".
The satellite number for each positioning system shows as follows:
• GPS: 1 to 32
• GLONASS: R01 to R24
• Galileo: E01 to E36
• QZSS: 193 to 197
Gray shaded area indicates area for the elevation mask that is set at
[SV ELEV] on the [GNSS Setup] tab. The equipment does not track
the satellite in this area.
Shows the SNR (signal-to-noise ratio) with the bar graph format, in
descending order of the elevation angle. When the SNR is 40 or
higher, the reception environment is good condition.
11
Remarks