Sensor Data Input; Introduction; Serial Interface Sensor Information - Furuno FICE-100 Installation Manual

2.2 Sensor Data Input

2.2.1. Introduction

Sensor data can be input either using:

Serial connector inside EC-3000 (IEC61162-1/2)

LAN interface from HUB-100 of ECDIS network (IEC61162-450)
Note that target information TT and AIS targets have to be received both either serial interface
or LAN interface. Only one interface can be used.

2.2.2 Serial Interface sensor information

Following sentences can be received by FICE-100/FOIL-200:
HDT, THS, GLL, GGA, VTG, ZDA, VBW, VHW, TTM, VDM, MTW
Below you can find connectors for serial line sensor data inside EC-3000 processor. Connector
J3 can be used for Gyro signal input (38400 bps). Connectors J5-J6 and J8-J10 can be used for
Gyro, EPFS, log and weather data signals (4800 bps). System automatically detects input
signals, i.e. there is no need to configure these ports.
Note, that connectors:

J4 is for VDM, AIS target data (38400 bps)

J7 is for TTM, Navigation radar tracket targets (4800 bps)
Connectors J3 and J4 are for IEC61162-2
Pin No
1
2
3
4
5
6
7
x= 1, 2
Signal
TDx-A
TDx-B
RDx-A
RDx-B
ISOGND
RDx-H
RDx-C
In/Out
out
out
in
in
in
in
Gyro 4800 bps
Gyro 38400 bps
Log 4800 bps
AIS 38400 bps
Weather 4800 bps
EPFS 4800 bps
TT 4800 bps
Description
No connection
No connection
IEC61162-2
IEC61162-2
Isolation ground
No connection
No connection
Page
6