Omron BL50T Instruction Manual page 14

Safety Precautions
Do not drop or give any strong impact when transport it.
● Overheating, smoke, explosion, or fire may occur in the battery.
■ Before starting using the product
After purchasing the UPS, charge the battery (for 8 hours or more) at
your earliest.
Wait for several hours before start using the UPS when it has been
moved from a cold place to a warm place.
Prepare for an unexpected circumstance, such as the data protection
and system redundancy.
■ For Connection
Do not connect a device with large maximum power consumption such
as a laser printer to the UPS.
Do not use the UPS for an induction device such as an induction coil,
motor, and transformer.
Make sure of checking the operation first before using the UPS in
combination with the devices with large fluctuations in power frequency,
such as a household power generator.
Prevent the short circuit between the output lines of the UPS, or the
output line on the earth (grounding.)
14
Cautions
● If not used for a long time after being purchased, the UPS may become unusable
because the characteristics of its battery become inferior.
● Insert the "AC input" plug of the UPS into the outlet (commercial power supply) to
charge the battery.
● If the UPS is suddenly moved to a warm place, water may adhere to it
(condensation). In such a case, if power is supplied without checking the
condition, the UPS may fail.
● The Uninterruptible Power Supply (UPS) may stop its output due to failure.
● Since a printer such as a laser printer has a large peak current, connected-
capacity overload may be detected when the peak current is reached.
● Depending on the device type, the UPS does not operate correctly due to the
influence of an inrush current and so on.
● When input power is supplied, the UPS automatically recognizes the input power
frequency. Connecting the UPS in a state where the input power frequency is out
of the specified value can cause the misrecognition of the power frequency,
which may result in the abnormal operation. It is okay for the power to switch
from the commercial power supply to the generator's power while the UPS is
running. However, adjust the frequency of the generator to match with the
commercial power supply.
● The UPS may fail.
(for tranportation)
Important notice
BL50T/BL75T/BL100T