Omron BL50T Instruction Manual page 8

Safety Precautions
When carrying the UPS, pay attention to its weight and balance, and
when using it, put it in a stable and robust place.
● There is a risk of injury if the product falls or drops.
● Weight:
BL50T: Approximately 5.2kg
BL75T: Approximately 5.8kg
BL100T: Approximately 6.4kg
● In a case of dropping the UPS, stop using the unit and immediately ask for the
inspection and repair.
For information about repair, contact Omron Electronics Repair Center.
● Be careful about crush injury when your fingers are in between the installation
surface and the bottom surface of the UPS.
Keep the plastic package bags away from children.
● Avoid the risk of a child playing with it to suffocate.
Be sure to connect the "AC input" of the UPS to a rated input voltage
(100VAC) and frequency 50/60Hz commercial power supply.
● Connecting to a power outlet (commercial power supply) with a different voltage
and frequency may cause a fire.
● The UPS may fail.
In case of an abnormality (abnormal noise/odor), stop the output by
turning off the "Power" switch on the UPS and pull the "AC input" plug
from the power outlet.
Install the "AC input" plug in such a way that it can be immediately
pulled out from the power outlet.
● For safety, follow the above instructions when maintaining the connected
equipment as well.
Do not connect the half-wave rectifier where the current flows only in a
half cycle of AC power supply, such as dryer and some solenoid valves.
● Overcurrent may damage the Uninterruptible Power Supply.
Connect to the power outlet (commercial power supply) with the
following current capacity.
・ BL50T: 7.5A
・ BL75T: 12A
・ BL100T: 15A
● Power wiring can catch heat.
● When a device with the maximum output capacity is connected, the current flows
as follows.
・ BL50T: 7.5A
・ BL75T: 12A
・ BL100T: 15A
8
Caution
(For installation and connection)
Caution
(For installation and connection)
BL50T/BL75T/BL100T