Omron BL50T Instruction Manual page 65

5 Processing for the automatic shutdown of the connected devices
2.
Install "PowerAct Pro", "Simple Shutdown Software", or "PowerAttendantLite" to
the PC you want to shut down.
<Installation procedure>
Refer to the "PowerAct Pro "installation guide.
"Simple Shutdown Software" "PowerAttendantLite": Refer to the manual for the
applicable software.
Restrictions on the commercial power supply stop time for a schedule action by
automatic shutdown software
・ To perform a schedule action for simultaneously stopping the UPS and the
commercial power supply by using a device such as a circuit breaker, specify a
period of 3 months or shorter (*) for the start of the next operation.
If you specify a period longer than 3 months, the internal timer is reset and the
scheduled operation does not start.
If commercial power is not supplied for more than 3 months, start supplying
commercial power and then press the "Power" switch to start operation. However, if
the battery needs to be replaced then, you may not be able to start operation. In
that case, replace the battery according to "4-2 Replacing the battery".
※Note that when the battery needs to be replaced, this period is reduced to a half.
To manually start operating the UPS while it is running based on a schedule action set
by automatic shutdown software, or to manually start up the UPS while it is stopped
based on a schedule action, turn off the "Power" switch once, and then turn it on again.
On the contrary, to manually stop the UPS while it is running based on a schedule
action, turn off the "Power" switch.
When "Automatically stop UPS after OS shutdown" is set, if power is restored during
the execution of automatic shutdown processing
・ Even if a power outage occurs and power is restored during the execution of
automatic shutdown processing, the output of the UPS stops once after the set time
elapses.
In that case, do not turn on the computer until the UPS has finished restarting after
power recovery.
References
After the UPS has automatically stopped during a power outage, if recovery is made
from the power outage, the UPS automatically reboots and starts supplying power.
If you do not want to activate the connected devices, either turn off their switches or
disable the automatic start setting for recovery from a power outage ([Settings] - [Boot
Settings] - [Auto Reboot])
BL50T/BL75T/BL100T
5-2 How to use automatic shutdown software
Important notice
5
65