Cisco Unified Wireless Ip Phone 7925G, 7925G-Ex, And 7926G Administration Guide - Cisco 7925G Administration Manual

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Web Pages
Item
TFTP
Obtain TFTP Servers
Automatically
Use the following
TFTP servers
TSPEC Settings
Minimum PHY Rate
Surplus Bandwidth
802.11G Power Settings
Channel
Status
MaxTxPower
802.11A Power Settings
Channel
Status
Description
Enables automatic assignment of
TFTP servers
Assigns static TFTP server IP
addresses to:
• TFTP Server 1
• TFTP Server 2
Minimum data rate that outbound
traffic uses. Modify this setting when
Call Admission Control (CAC) is
enabled.
Note Cisco APs support only
PHY rates of 6, 11, 12, or
24. The default is 12. If you
use an access point that uses
802.11b, the PHY rate must
be configured to the
supported rate.
Excess bandwidth beyond application
requirements
Assigns the channels
Enabled: Identifies enabled channels
in WLAN to improve scanning for
the phone.
Sets the maximum transmit power
for the phone
Assigns the channels
Enabled: Identifies enabled channels
in WLAN to improve scanning for
the phone

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide

Network Profile Settings
For more information, see ...
Set Up Alternate TFTP Server, on page 93
Set Up Advanced Profile Settings, on page
94
Set Up Advanced Profile Settings, on page
94
Set Up Advanced Profile Settings, on page
94
79