Dhcp Settings - Cisco 7925G Administration Manual

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Settings

DHCP Settings

The Cisco Unified IP Phones enable DHCP, by default, to automatically assign IP addresses to devices when
you connect them to the network. If you do not use DHCP in your network, then you must disable DHCP and
manually enter the network configuration information.
Use these guidelines when manually configuring the IP settings:
• Ensure the TFTP server has an IP address.
• Ensure the default router IP address is on the same subnet as the host IP address.
When DHCP is enabled, you cannot configure IP settings, but you can configure an alternate TFTP server.
Note
Related Topics
Dynamic Host Configuration Protocol Server Interactions, on page 38
Disable DHCP
To disable DHCP on the phone and manually configure IP settings, follow these steps:
Procedure
Step 1 Choose SETTINGS > Network Profiles.
Step 2 Scroll to the profile name that you want to configure and press the View softkey.
Step 3
Enter **# to unlock the profile and press Edit.
Step 4 Select Network Configuration. Press View.
Step 5 Scroll to DHCP Enabled and press No.
Step 6 Scroll to IP Address and press Select.
Step 7
In the New IP Address field, enter the static IP address for the phone.
Step 8 Press Options > Validate to save the entry or press Options > Cancel.
Step 9 After you disable DHCP, you must enter the other required static fields. See
DHCP, on page 122
For information about entering values, see
for descriptions of these fields.
Network Profile Data Input Guidelines, on page
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
DHCP Settings
Static Settings with Disabled
118.
121