Charge Phone Battery Using Usb Cable And Pc - Cisco 7925G Administration Manual

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup

Charge Phone Battery Using USB Cable and PC

The following figure shows how to connect your phone to a PC to charge the phone battery.
Figure 8: Charge the phone battery using the USB cable and PC
Procedure
Step 1 Insert the phone connector on the USB cable into the phone.
Step 2 Insert the USB A-type connector into the USB port on your PC.
Step 3
Monitor the indicator light after the phone briefly displays USB Connected on the status line.
Step 4 If you see the Found New Hardware Wizard popup message, stop the wizard from opening when
connecting to USB port, using the following steps:
a) Click Next to use the wizard dialog box.
b) In the Update New Software dialog, click No, not this time, and click Next.
c) Click Install the Software automatically (Recommended) and click Next.
d) After a few moments, the Cannot Install This Hardware dialog displays. Click Don't prompt me again
to install this software.
e) Click Finish to close the dialog box.
Note
Related Topics
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Startup, on page 63
Install or Remove Phone Battery, on page 55
Charge Phone Battery Using Power Supply, on page 58
While the battery is charging, the indicator light is red. When the battery is fully charged, the indicator
light turns green. Charging times are longer when you use this method and are described in
Power, on page 54.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
Phone Power
Phone
59