Installer Checklist - Lennox iComfort M30 Installation And Setup Manual

Installer Checklist

Item Description
1 Is the thermostat properly mounted to either a wall stud or wall? (Do not mount on exterior wall or near any
ventilation outputs, doorways or location that could be directly exposed to sunlight)
2
Are all terminals wiring properly connected and tight?
3 When required, is the outdoor air temperature sensor (OATS) properly connected and isolated when used?
Is the input enabled using the user interface? Go to advanced settings > outdoor sensor and set
to YES if not done so already. Then go to settings > display and make sure the outdoor temperature
display setting is configured for sensor. If OATS is not used, leave the setting on Internet.
4
Have all the Thermostat Features been explained to the Home Owner?
5 Has User manual been given to Home Owner?
6 Has additional Alexa information not in user manual been given to Home Owner and shown where to find
answers to additional questions?
Go to www.myicomfort.com Support page & FAQ.
7 Is the Wi-Fi connected?
8 Can the homeowner access the consumer portal (www.myicomfort.com) from either a PC or tablet?
9 Has the homeowner downloaded the Lennox Thermostat application from either Google Play or IOS App
Store to their mobile devices?
10 Is the Lennox Dealer account number or your main shop phone number been added to the dealer information
screen? This will tie the homeowners system to your LennoxPROS account.
11 If applicable, has the air handler's electric heat strips been commissioned? If not, commissioning of heat
strips must be performed.
12 Has a complete system test been run? If not, from the HD Display home screen go to settings >
advanced settings > view dealer control center > and select tests.
Table 13. Installation Checklist
39
Yes No