System Test Modes
After the thermostat has been installed and set-
up, the installer may run a system test function
(accessed through the installer settings menu), to
test all cooling, heating, emergency heating stages
and FAN outputs.
Select system test mode. A pop-up will be
displayed indicating all equipment will be stopped.
Touch confirm to continue.
Pressing the OFF button next to the desired option
will change the status to ON and will enable the
relay for that terminal. Pressing again will turn OFF
the relay. Touch the left arrow (<) to exit the system
test mode.
Save Energy Default
Energy saving recommended set points for heating
and cooling can help save energy. The time and
temperatures reference in the following table are
pre-programmed into the thermostat to achieve
energy savings.
Scroll to ENERGY SAVING DEFAULT; touch to
select. Read the message on the screen and to
continue, touch CONFIRM.
Table 8. Energy Saving Set Points
Time
Wake
Leave
Return
Sleep
NOTE: Humidification and dehumidification are not part of the
energy savings program. A higher utility bill may occur
when not using the setpoints in this table.
33
Heating
Cooling
70°F (21°C)
78°F (25°C)
62°F (17°C)
85°F (29°C)
70°F (21°C)
78°F (25°C)
62°F (17°C)
82°F (28°C)