Table of Contents
Advertisement
REMOVING VALVE
1) Shut off the gas supply.
2) Remove the louvers (and bay door if it has
been installed).
3) Open the fl ush door and remove the door.
4) Remove the logs and side brick panels, if
installed.
5) Remove the grate by lifting up and out.
Grate
6) Remove the burner by removing the screw
on the left side and then slide the burner to
the left and lift out.
Remove the screw on the left
side of the burner.
Slide the burner to the left and lift out.
®
Regency
P48-2 Zero Clearance Direct Vent Gas Fireplace
7) Remove the right and left side defl ectors by
removing the 2 screws on each defl ector.
Right Side
Defl ector
Left Side
Defl ector
8) Remove the base brick panels.
9) Disconnect the inlet gas line.
10) Remove the 10 Phillips head screws securing
the valve tray assembly in place and then
lift the entire assembly out.
Valve Tray
Assembly
MAINTENANCE
Lift entire valve tray
assembly out.
11) Disconnect the 2 TP wires and the 2 TH
wires from the valve.
12) Undo the pilot tube from the valve with a
7/16" wrench.
13) Undo the quick drop out thermocouple nut
on the valve with a 9mm (metric) wrench.
14) Remove the Piezo igniter wire and push
button assembly.
Thermopile
Thermocouple
Wire
Wire
15) Undo the "gas out" fl are nut with a 13/16"
wrench.
16) Undo the "gas out" fl are fi tting with an 11/16"
wrench.
17) Remove the 4 Phillips head screws from
the sides of the valve bracket and remove
valve.
Hint:
If you are using black pipe, ensure
that there is a union by the valve,
otherwise removal will be almost
impossible.
Pilot Nut
45
Advertisement
Table of Contents
