Venting Arrangements; Horizontal Termination - Regency P48-2 Owners & Installation Manual

Regency gas fireplace owners & installation manual

Owners & installation manual (53 pages)

Table of Contents

These venting systems, in combination with the P48-2 Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system by

Warnock Hersey. The location of the termination cap must conform to the requirements in the Vent Terminal Locations diagram in "Exterior Vent

Termination Locations" section.

Regency

Direct Vent (Flex) System

Termination Kit (Part# 946-618) includes all

the parts needed to install the P48-2 with a

maximum run of 4 feet.

1) 8" dia. ﬂ exible liner (6 ft. length)

2) 5" dia. ﬂ exible liner (6 ft. length)

3) spring spacers (4)

4) thimble (2)

5) AstroCap XL termination cap (1)

6) screws (12)

7) tube of Mill Pac (1)

8) plated screws (8)

9) screws #8 x 1-1/2" Drill Point,

Stainless Steel (4)

10) vinyl siding standoff

If longer runs are needed, the Regency

Vent system (Flex) Part# 946-616 includes all

the parts needed to install the P48-2 with a

maximum 10' run.

1) 8" dia. ﬂ exible liner (10 ft. length)

2) 5" dia. ﬂ exible liner (10 ft. length)

3) spring spacers (7)

4) thimble (2)

5) AstroCap XL termination cap (1)

6) screws (12)

7) tube of Mill Pac (1)

8) plated screws (8)

9) screws #8 x 1-1/2" Drill Point,

Stainless Steel (4)

10) vinyl siding standoff

Notes:

1) Liner sections should be continuous without any joints or seams.

2) Only Flex pipe purchased from Regency

3) If you are installing the P48-2 into a Regency

include the mantel base in your calculations and to maintain the 2-1/2" clearance to the underside of the mantel top.

Regency

P48-2 Zero Clearance Direct Vent Gas Fireplace