Panasonic GT703 User Manual page 99

 Ethernet port
Item
Interface
Baud rate
Connector shape
Cable total length
Communication cable
LINK/ACT lamp
(Note 1): Switching between different speeds is done automatically by auto negotiation function.
(Note 2): Take care of handling of the connector not to add an excessive static electricity on the metal part
(Note 3): The standards cite 100 m as the maximum, but noise resistance measures such as attaching a ferrite core
may be necessary in some cases, depending on the usage environment. Also, if the hub is positioned close to a
control board, we recommend using it at a distance of 10 m or less.
(Note 4): The LAN port is insulated from the internal circuit.
* When using it as tool port, the GT cannot communicate with multiple tools (PC) including USB port simultaneously.
 SD memory card
Item
Support media (Note 1)
Supported format standard
(Note 1): Check the usable temperature range of a SD memory card to be used before use.
Cautions on handling a SD memory card
The data saved in the SD memory card may be lost in the following cases. We assume no
responsibility whatsoever for the lost of saved data.
1) When a user or third party used the SD memory card incorrectly.
2) When the SD memory card was affected by any static electricity or electrical noise.
3) When the SD memory card was removed or the power supply of the GT unit was turned off
while data was being read, written or deleted to/from the SD memory card.
* It is recommended to save important data in another media for backup.
Specifications
100BASE-TX／10BASE-T
100Mbps/10Mbps automatic negotiation (Note 1)
Plug-in phone jack (RJ-45) (Note 2)
100 m (500 m when using a repeater) (Note 3)
UTP cable (Category 5)
Light on: When linked
Blinking: During data reception.
Specifications
SD memory card, SDHC memory card
(The manufacturer that the operation check has done: Panasonic
Corporation)
Conforms to SD standard
(Please format with format software for SD memory cards.)
6.2 GT704 Specifications
6-11