Panasonic GT703 User Manual page 32

Installation and Wiring
 Wiring method
(1) Remove a portion of the wire's insulation.
(2) Insert wire into terminal hole until it stops. Tighten screw clockwise to fix wire in place.
 Precautions concerning wiring
The following precautions should be observed, to avoid broken or disconnected wires.
• When removing the wire's insulation, be careful not to scratch the core wire.
• Do not twist the wires to connect them.
• Do not solder the wires to connect them. The solder may break due to vibration.
• After wiring, make sure stress is not applied to the wire.
• In the terminal block socket construction, if the wire is fastened upon counter-clockwise
rotation of the screw, the connection is faulty. Disconnect the wire, check the terminal hole,
and then re-connect the wire.
REFERENCE
For details of the connection with PLCs, refer to "4.1 Connection with PLC".
3-8