When Performing General-Purpose Serial Communication - Panasonic GT703 User Manual

Troubleshooting

5.2.8 When Performing General-purpose Serial Communication

Error code
**0000 BCC error
**0001 Format error
**0002 NOT support error
**0003 Address error
Receive buffer
**0004
Overflow
**0005 Requested overflow
**0006 Data error
**0007 Data write inhibit error
5-12
Error name
The value of BCC may be incorrect. Check if there is no
calculation mistake.
A command format may be incorrect. Check if it is correct.
A command used is not supported with the version of the GT.
Upgrade the version of the GT, or use another command.
The address specified does not exist in the GT. Check the
address of the sent command.
The sent command exceeds the receivable number of bytes.
Check the number of bytes of the sent command.
The sent readout command exceeds the number of bytes that can
send back. Check the number of the read words.
The communication condition for the GT may be unmatched with
the condition for a destination device. Check the communication
conditions.
A command for the address that writing is not available was sent.
Check the address of the sent command.
Countermeasures