Table of Contents
Advertisement
Installation and Wiring
3.1.5 Installation Method
Secure the GT to the installation panel using the fittings and screws (4 sets/per unit) provided
with the unit.
PROCEDURE
1. Place the GT main unit in the installation panel.
2. Insert the fittings into the grooves provided in the GT main unit, and tighten
the screws to secure the GT main unit to the installation panel.
The figure shows the example of GT704.
The cross slot screwdriver no. 1 must be used.
•
•
The tightening torque should be 0.2 to 0.3 Nm.
•
Tightening the screws too hard can cause deformation of the front panel, so
that the touch switches will not function properly. Install the GT within the
above range.
3-4
Advertisement
Table of Contents
