Omron NX-ID User Manual page 90

4 Installation and Wiring
Using Ferrules
If you use ferrules, attach the twisted wires to them.
Observe the application instructions for your ferrules for the wire stripping length when attaching fer-
rules.
Always use plated one-pin ferrules. Do not use unplated ferrules or two-pin ferrules.
The applicable ferrules, wires, and crimping tools are listed in the following table.
Terminal
types
Terminals
other than
ground ter-
minals
Ground ter-
minals
Terminals
other than
ground ter-
minals
*1. Some AWG14 wires exceed 2.0 mm
When you use any ferrules other than those in the above table, crimp them to the twisted wires so that
the following processed dimensions are achieved.
1.6 mm max.
(Terminals other than ground terminals)
2.0 mm max.
(Ground terminals)
4 - 14
Manufac- Ferrule
turer model
Phoenix AI0,34-8
Contact
AI0,5-8
AI0,5-10
AI0,75-8
AI0,75-10
AI1,0-8
AI1,0-10
AI1,5-8
AI1,5-10
AI2,5-10
Weidmuller H0.14/12
H0.25/12
H0.34/12
H0.5/14
H0.5/16
H0.75/14
H0.75/16
H1.0/14
H1.0/16
H1.5/14
H1.5/16
2
and cannot be used in the screwless clamping terminal block.
Applica-
ble wire
2
(mm
(AWG))
0.34 (#22) Phoenix Contact (The figure in parentheses is the
applicable wire size.)
0.5 (#20)
CRIMPFOX 6 (0.25 to 6 mm
0.75 (#18)
1.0 (#18)
1.5 (#16)
*1
2.0
0.14 (#26) Weidmuller (The figure in parentheses is the appli-
cable wire size.)
0.25 (#24)
0.34 (#22)
PZ6 Roto (0.14 to 6 mm
0.5 (#20)
0.75 (#18)
1.0 (#18)
1.5 (#16)
8 to 10 mm
2.4 mm max.
(Terminals other than ground terminals)
2.7 mm max.
(Ground terminals)
NX-series Digital I/O Unit User's Manual (W521)
Crimping tool
2
, AWG24 to 10)
2
, AWG26 to 10)