Omron NX-ID User Manual page 113

Wire Size
We recommend using cable with wire gauges of AWG 24 or AWG 28 (0.2 mm
cable with external wire diameters of 1.61 mm max.
Wiring
NX Units with MIL Connectors
• Make sure that all Units are connected properly.
• After the cable side connector is connected, close the lock lever on the NX Unit side connector sec-
tion to lock it. After you complete the wiring, make sure that the connector is locked.
NX Units with Fujitsu Connectors
1
Check that each Unit is installed securely.
Precautions for Correct Use
Do not force the cables.
2
When solder-type connectors are being used, be sure not to accidentally short adjacent termi-
nals.
Cover the solder joint with heat-shrink tubing.
NX-series Digital I/O Unit User's Manual (W521)
Solder-type connector
→
Heat-shrink tubing
Wire (0.2 to 0.13 mm
4 Installation and Wiring
2 )
2 2
to 0.08 mm ). Use
4 - 37
4