Auxiliary Windows; References Window; Flight Id; Figure 2-29 References Window - Garmin G1000 Reference Manual

SECTION 2 – PFD

2.7 AUXILIARY WINDOWS

The lower right area of the PFD is a shared area that, at
any one time, can present the following windows:
• TIMER/REFERENCES
• NEAREST
• DIRECT-TO
• FLIGHT PLAN
• PROCEDURES
• ALERTS
• PFD SETUP (Lighting)

References Window

The Timer/References window (Figure 2-29) is enabled
and disabled by pressing the TMR/REF softkey. The fol-
lowing Vspeeds and Vspeed bugs can be set using the
Timer/References window:
• Rotation speed reference (Vr)
• Vr bug (ON, OFF)
• Best angle-of-climb speed reference (Vx)
• Vx bug (ON, OFF)
• Best rate-of-climb speed reference (Vy)
• Vy bug (ON, OFF)
• Best glide speed reference
• Best glide speed bug (ON, OFF)
• Generic timer
• Timer direction (count UP or DOWN)
• START, STOP or RESET
Vspeed References
30

Figure 2-29 References Window

Garmin G1000 Cockpit Reference Guide for Cessna Nav III
Vspeed values for Cessna Nav III aircraft are found in
their respective Aircraft Flight Manuals. All default speeds
can be restored by pressing the MENU key, selecting 'Re-
store Defaults' and pressing the ENT key. Default settings
are automatically restored when power is cycled, and are
consistent with the values in the Cessna Aircraft Flight
Manual. The G1000 PFD Pilot' s Guide describes Vspeed
settings and operations in detail.

Flight ID

Flight status automatic reporting of aircraft identifica-
tion (ID) is transmitted from the GTX 33 to the ground
stations and other aircraft.
The flight ID is set to fixed ("SAME AS TAIL" and
"CONFIG ENTRY"), or variable ("PFD ENTRY") at the time
of installation. The two fixed selections do not require any
action from the pilot. The variable ("PFD ENTRY") flight ID
requires the pilot to enter the flight ID on the Timer/Refer-
ences window each time the G1000 is powered on.
NOTE: If the G1000 is set to variable ("PFD
ENTRY") and the flight ID entry field on the
Timer/References window is not visible, the pilot
should contact a Garmin-authorized Service
Center.
To enter or change the Flight ID:
1. Press the TMR/REF softkey, then turn the large
FMS knob to highlight the flight ID field.
Turn the FMS knobs to enter the desired flight
2.
ID. Press the ENT key to update the flight ID.
Flight ID