Spa Maintenance - Jacuzzi MAXI-PREMIUM J-210 Installation Manual And Use & Maintenance

F4: 1 hour of filtering/heating per day
(one half-hour cycle every 12 hours)
F5: 1 1/2 hours of filtering/heating per day
(a half-hour cycle every 8 hours)
F6: 2 hours of filtering/heating per day
(one half-hour cycle every 6 hours)
I
Lock modes
see "filtering mode for models without circulation pump"

Spa maintenance

Proper and regular maintenance of your spa will help it retain
its beauty and performance.
I
Cleaning the filter (models J-210)
The Jacuzzi ® Premium spa is equipped with a basket and a high-
performance filter cartridge, located in the compartment on the
inner wall of the spa.
Impurities are filtered by the pump which draws water into the
basket and filter cartridge which, for best performance, must be
cleaned about once a month, depending on frequency of use of
the spa. For this purpose, proceed as follows:
A. Turn off power to spa.
B. Remove the cover, unscrew the cartridge and extract it.
C. Rinse the impurities out of the folds in the filter using pres-
surised water. Work from the top down. Repeat until all folds are
clean.
I
Cleaning the filter (models J-230, J-270 and J-280)
These models are equipped with a bag and a high-performance
filter cartridge, located under the cover, as shown below.
Impurities are filtered by the circulation pump (if included) or by
pump 1, which draws water into the bag and filter cartridge
which, for best performance, must be cleaned about once a
month, depending on frequency of use of the spa. For this pur-
pose, proceed as follows:
A. Turn off power to spa.
B. Remove the cover by lifting it
C. Release the skimmer bag from the clips and clean it.
D - E. Remove the filter cartridge by turning it counter-clockwise
(to release it from the fitting) and extract it.
F. Rinse the impurities out of the folds in the filter using pres-
surised water. Work from the top down. Repeat until all folds are
clean.
G. Immerge the cartridge of the filter in the spa, with the thread-
ed end up to remove trapped air bubbles. Then hold the cartridge
under water, so as to prevent possible air bubbles from forming
during installation.
H. Place the cartridge back in the housing, and turn it clockwise
to re-install it on the fitting.
Note the direction of installation.
Do not over tighten.
I. Install clean skimmer bag back onto clips.
J. Install the filter cover. Turn power to the mini-pool back on.
B
E
H
I
The filter cartridge must be thoroughly cleaned on a regular basis.
It is advisable to soak the filter overnight in a plastic container filled
with a solution of water and a specific cleaning product.
I
The cartridge has a life cycle of about two years, provided it un-
dergoes regular maintenance and is used with good quality water.
22
D
C
F G
J
I