DataCard CE870 Installation And Administrator's Manual page 40

4.
Set the static IP address, subnet mask, and gateway address.
a.
Press E
NTER
displays on line 2.
b.
Press E
NTER
The IP address has four sections, separated by periods. A
cursor appears under the digit that will change.
i.
Use the arrow keys to change one digit at a time.
ii.
The address section shows three digits when it can
be changed and the cursor is under the right-most
digit. Press E
the address.
iii.
When all four sections are correct, press E
Subnet Mask displays on line 2 of the LCD panel.
c.
Repeat steps i through iii to enter the subnet mask
and gateway address.
5.
Press E
NTER
address information. Apply displays on line 2.
6.
Press E
NTER
7.
Press the down arrow key to scroll to Exit on line 2.
8.
Press E . Then, press the U
NTER
glows green.
28
to enter the Static IP menu. IP Address
to set the static IP address.
to navigate to the next section of
NTER
when you finish entering all the required
to apply your changes.
button to return the printer to Ready. The U
SER
.
NTER
button
SER
Installation