DataCard CE870 Installation And Administrator's Manual page 29

3.
Prepare the ribbon for routing.
a.
Roll up one full turn of indent
ribbon on the take-up spool.
b.
Roll out a slack length of indent
ribbon from the supply spool.
4.
Route the ribbon around the rollers on
the indent ribbon cartridge. A diagram
on the cartridge shows the correct
routing pattern.
IMPORTANT! Do not twist the ribbon
while routing.
5.
Secure the take-up spool to the
spindle.
a.
Match the keyed pattern of the
take-up spool hub with the right
side spindle.
b.
Push the take-up spool into the
spindle until it clicks securely into
place.
6.
Turn the take-up spool one full turn
clockwise to take up ribbon slack.
7.
Replace the indent ribbon cartridge.
a.
Hold the cartridge by its handle.
b.
Align the cartridge with the guides inside
the embosser.
c.
Slide the cartridge in until it clicks and
stops.
CE870 Instant Issuance System Installation and Administrator's Guide 17