Counter Output Applications
Simple Pulse Generation
© National Instruments Corporation
Figure 7-20 shows an example of a buffered two-signal edge-separation
measurement.
AUX
GATE
SOURCE
Counter Value
Buffer
Figure 7-20. Buffered Two-Signal Edge-Separation Measurement
For information about connecting counter signals, refer to the
Counter/Timer Pinouts
Single Pulse Generation
The counter can output a single pulse. The pulse appears on the Counter n
Internal Output signal of the counter.
You can specify a delay from when the counter is armed to the beginning
of the pulse. The delay is measured in terms of a number of active edges of
the Source input.
You can specify a pulse width. The pulse width is also measured in terms
of a number of active edges of the Source input. You also can specify the
active edge of the Source input (rising or falling).
1
2
3
1
3
section.
7-19
Chapter 7
Counters
2
3
1
2
3
3
3
3
3
3
Default
M Series User Manual