How To Adjust The Function Ramp Rate Setting - Genie ZX-135/70 Service And Repair Manual

Service and Repair Manual
Platform Controls
How to Adj ust the Functi on R amp R ate Setti ng
How to Adjust the Function Ramp
Rate Setting
The ramp rate setting of a joystick controls the time
at which it takes for the joystick to reach maximum
output, when moved out of the neutral position. The
ramp rate settings of a joystick can be changed to
compensate for hydraulic pump wear to maintain
peak performance from the machine.
Note: Perform this procedure with the boom in the
stowed position.
Note: Use the following chart to identify the
description of each LCD screen control button used
in this procedure.
Plus Minus
1 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
2 Press and hold the enter button on the ground
control panel while turning the key switch to
platform controls. Hold the enter button for
approximately 5 seconds.
3 Press the plus button twice, then press the
previous button twice.
28
Previous Enter
ZX®-135/70
4 Press the previous button until the function to
be adjusted is displayed.
5 Press the plus button to increase the ramp
rate or press the minus button to decrease the
ramp rate.
6 Press the enter button to save the setting in
memory.
7 Press the enter or previous button on the
LCD screen until EXIT is displayed.
8 Press the plus button or minus button to
select YES and then press the enter button.
April 2018
Part No. 1279835GT