Telematics Connector Pin Legend - Genie ZX-135/70 Service And Repair Manual

April 2018
Genie installed Telematics connector is wired with an Active High digital input.
Note: A Deutsch plug p/n DT06-08SA mates with the Genie Telematics connector
Pin Circuit Type
1 System Power
2 System Ground
3 Digital Output 1
4 Digital Output 2
5 Digital Output 3
6 Digital Input 1
7* Databus H
8* Databus L
* Tier IV engine models only, J1939 engine message available.
* Genie proprietary databus support.
Wireless Certifications
Telematic device(s) should comply with specific wireless carrier certifications where applicable and comply with the
following:
North America
Europe
Part No. 1279835GT

Telematics Connector Pin Legend

Connector Pin Numbering
Circuit Properties Genie Machine Function(s)
12 VDC Battery Positive – constant power
5 Amp Max. allowed
draw
0 VDC Battery Negative
12 VDC Engine Run Hour Meter
12V = engine run, 0V = engine off
12 VDC Key Switch Activation
12V = key switch on, 0V = key switch
off
12 VDC Foot switch
12V = active, 0V = inactive
12 VDC Remote Disable Engine Start
CAN HIGH Genie Databus
CAN LOW Genie Databus
PTCRB, FCC/IC
CE, R&TTE
ZX®-135/70
Service and Repair Manual
Telematics Use Case
Supply power to device
Device Ground
Monitor Engine Hours
Monitor machine utilization
Monitor machine utilization
Remotely Prevent Engine Start
J1939 Engine Messages, Receive
Proprietary Genie Telematics
Message
J1939 Engine Messages, Receive
Proprietary Genie Telematics
Message
205