Chapter 4 G-Code Control Parameters - Mitsubishi Electric MELSEC iQ-R16MTCPU Programming Manual

4
G-CODE CONTROL PARAMETERS
This chapter describes the parameters used for G-code control.
Refer to the following for R series common parameters, and Motion CPU common parameters.
MELSEC iQ-R Motion Controller Programming Manual (Common)
Refer to the following for Motion control parameters.
MELSEC iQ-R Motion Controller Programming Manual (Positioning Control)
When using G-code control set the following. If the following settings are not made G-code control cannot be
performed.
• Set "0.888ms" or more in [Motion CPU Common Parameter][Basic Setting]"Operation Cycle".
(Page 24 Control Cycle of G-Code Control)
• According to the lines being used, set "Use Line 1 only" or "Use Line 1 and Line 2" in [Motion CPU Common
Parameter][Basic Setting]"G-code Control Setting"
4 G-CODE CONTROL PARAMETERS
72