Appendix 2 G-Code Control Event Details Codes; G-Code Control Event Details Codes - Mitsubishi Electric MELSEC iQ-R16MTCPU Programming Manual

Appendix 2

G-code control event details codes

The detail codes when a G-code control event is detected are shown below.
Detailed information 1
■G-code control system information (information (event code: 07FAH))
The details codes for when G-code control system information (information (event code: 07FAH)) is detected are shown
below.
Details code Description
0401H G-code control request
ON
0402H G-code control request
OFF
0403H Reset command ON
during program start
0404H Automatically operation
pause (feed hold) ON
0405H Single block stop
0406H Cutting override zero
0407H Fast forward override
zero
G-code Control Event Details Codes
Details
Turned OFFON "[Rq.3376] G-code control request"
Turned ONOFF "[Rq.3376] G-code control request"
Turned OFFON "[Rq.3380] Reset command" during program starting.
"[Rq.3378] Automatic operation hold (feed hold)" turned ON.
(Automatic operation can be restarted by turning OFFON "[Rq.3377] Automatic operation start (cycle start)".)
Operation was stopped by single block.
(Automatic operation can be restarted by turning OFFON "[Rq.3377] Automatic operation start (cycle start)".)
Cutting feed rate override is set to "0", or a value outside the setting range was set.
Fast forward rate override is set to "0", or a value outside the setting range was set.

Appendix 2 G-code Control Event Details Codes

A
APPENDICES
243