G-Code Control Common Monitor Device - Mitsubishi Electric MELSEC iQ-R16MTCPU Programming Manual

3.4

G-Code Control Common Monitor Device

Device No.
MELSEC iQ-R Q series Motion
Motion device compatible
assignment device
assignment
D54480
D54481
D54482
D54483
D54484
D54485
D54486
D54487
D54488
D54489
D54490
D54491
D54492
D54493
D54494
D54495
[Md.3000] G-code control setting operation cycle (D54480)
The G-code control operation cycle is stored in [s] units.
The control cycle for G-code control operates at the following cycles according to "Motion setting operation cycle (SD523)".
When "Motion setting operation cycle (SD523)" is shorter than 0.888[ms], a moderate error (error code: 30FEH) occurs, and
G-code control cannot be used.
Motion setting operation cycle (SD523)
0.888[ms]
1.777[ms]
3.555[ms]
7.111[ms]
[Md.3001] G-code control operation cycle (D54481)
The time taken for G-code control operation processing is stored in [s] units every G-code control operation cycle.
[Md.3002] G-code control maximum operation cycle (D54482)
After Multiple CPU system power supply ON, the maximum time taken for G-code control operation processing is stored in
[s] units every G-code control operation cycle.
[Md.3003] Program load status while running (D54492)
The status of the program load while running is stored.
Monitor values
0
1
2
3
3 G-CODE CONTROL DEDICATED SIGNALS
32
3.4 G-Code Control Common Monitor Device
Symbol Signal name
Md.3000 G-code control setting operation cycle
Md.3001 G-code control operation cycle
Md.3002 G-code control maximum operation
cycle

Unusable
Md.3003 Program load status while running
Md.3004 Program load error information while
running

Unusable
[Md.3000] G-code control setting operation cycle (D54480)
3.555[ms]
7.111[ms]
14.222[ms]
28.444[ms]
Description
No request
Executing
Successfully completed
Failed
Refresh cycle Fetch cycle

STOPRUN
G-code control
operation cycle
 

Main cycle
 
Signal type
Monitor device

Monitor device
