Trip Screen; Water Temperature; Timers - Raymarine ST60 Tridata Owner's Handbook Manual

6

Trip screen

The trip screen shows the distance covered since the trip value was last
reset.
The trip value is reset automatically at power-up, and if the instrument is
operating as a master, the trip value can also be reset manually by
pressing the

Water temperature

The water temperature is shown in either degrees Celsius (°C) or
Fahrenheit (°F), as set during calibration (see Chapter 4, Calibration).

Timers

The count-up timer and to the two race-start timer times are either in
seconds (S) or minutes (M), depending on the counter values.
Refer to the Using the trip key flow diagram to display the required timer.
Once you have done this, press the reset key to start the timer running.
When a timer is running, the delimiter (i.e. '.'or ':') flashes. For lap
timing, press the reset key. To stop and reset a timer to the start value,
hold down the reset key for 1 second.
Once a timer is running, you can leave the timer page and select any other
display. The counter will continue to run in the background.
Race-start timers
You can set each race-start timer to any whole-minute value from 1 to 15
minutes.
Note: When the instrument is first installed, the race-start timers are set
to 4 and 5 minutes respectively.
To set a race-start timer:
1. Use the trip key as shown in the Using trip key flow diagram to select
2. Simultaneously press the trip and reset keys to enter the race-start
3. Use either the trip or reset key to set the required value.
4. Simultaneously press the trip and reset keys to save the value and
reset key for 3 seconds.
the required race-start timer.
timer adjust mode.
leave the race-start timer adjust mode.
ST60 Tridata Instrument Owner's Manual