Chapter 3: Installation; Planning Your Installation; Site Requirements; Transducers - Raymarine ST60 Tridata Owner's Handbook Manual

Chapter 3: Installation

Chapter 3: Installation
This chapter describes how to install the ST60 Tridata instrument, and
associated Speed and Depth transducers. The transducers are fitted in the
hull of the vessel and connected to the rear of the instrument. The actual
type of transducers depends on the type of hull in which they are to be
installed.
For advice, or further information regarding the installation of this
equipment, please contact the Raymarine Product Support Department
or your own National Distributor.

3.1 Planning your installation

Before starting the installation, spend some time considering the best
positions for both transducer and instrument, such that the Site
Requirements and the EMC Guidelines (below) are satisfied.

Site requirements

Transducers

The transducer types required for the various hull types are as follows:
75 mm (2.94 in)
diameter
Depth
5 mm
51 mm (2.0 in)
(0.19 in)
diameter
75 mm (2.94 in)
diameter
75 mm (2.94 in)
diameter
Speed
51 mm (2.0 in)
diameter
75 mm (2.94 in)
diameter
13
14 mm
(0.57 in)
D4447-4