Functional Test - Repeater Units Only - Raymarine autopilot Owner's Handbook Manual

Chapter 5: Installing the ST6001+
5.5 Functional test – repeater units only
If you have installed the ST6001+ as an additional control unit for an
existing autopilot system, complete the following checks to make
sure you have installed the control unit correctly.
Note: If you have connected the ST6001+ as part of a new autopilot
installation, you MUST calibrate the autopilot as described in
Chapter 6: Commissioning the Autopilot.
Switch on
1. When you have installed the ST6001+ control unit, switch on the
2. If the control unit is active and the system operating, the control
3. After 2 seconds, the control unit will display the STANDBY screen.
SeaTalk and NMEA connections
If you have connected the ST6001+ to other SeaTalk instruments or
control units, check the links as follows:
1. Select display lighting level 3 ( LAMP 3 ) on one of the other
2. The ST6001+ should immediately switch on its display lighting:
3. If you have connected an NMEA navigator to the control unit
Troubleshooting
•
•
main power breaker.
unit will beep and display the control unit type ( ST6001 ) for
2 seconds.
SeaTalk instruments or control units.
• if the lighting does not switch on, there is a fault in the SeaTalk
cabling between the ST6001+ and the other units
NMEA inputs, check the connections as described on page 57.
If the head does not beep, check the fuse/circuit breaker.
If the display shows the SEATALK FAIL alarm message, check the
SeaTalk connections.
53