Transmission Of Nmea Data On Seatalk; Functional Test (Repeater Unit) - Raymarine ST7000+ Owner's Handbook Manual

Chapter 5: Installation
Data
Latitude and Longitude
Course Over Ground
Speed Over Ground
Cross Track Error
Bearing to Waypoint
Distance to Waypoint
Waypoint Number
Apparent Wind Speed
Apparent Wind Angle
Speed Through Water
Depth
Water Temperature

Transmission of NMEA Data on SeaTalk

If any of the above NMEA data is received and the equivalent data is
not present on SeaTalk, the ST7000 Plus will transmit the data onto
SeaTalk to make it available to other SeaTalk compatible instruments.
Depth is transmitted in the units defined by the first depth page in the
data page rollover. Water temperature is always transmitted in ºC.
If you wish to transmit NMEA information to other equipment a
SeaTalk-to-NMEA bridge should be installed.

5.4 Functional Test (Repeater Unit)

If you have installed your ST7000 Plus as a repeater unit on an
autopilot system, you should perform the functional test described in
this section. However, if you have installed the ST7000 Plus as the
only control unit for a Type 100/300 course computer, you should now
carry out the procedures in Chapter 6, Post Installation Procedures.
NMEA 0183
GLL, RMC, RMA, GLP, GOP, GXP, GGA,
GDP
VTG, RMC, RMA
VTG, RMC, RMA
APB, APA, RMB, XTE
APB, BWR, BWC, RMB
BWR, BWC, RMB
APB, APA, BWR, BWC, RMB
VWR, MWV
VWR, MWV
VHW
DBT
MTW
63