48
Flush mount control units
To fit a flush mount control unit:
1. Ensure that the intended mounting location is between 3 mm
2. Apply the flush mount template (supplied at the back of this
3. Use a jigsaw to cut out this aperture.
4. Peel the protective sheets from the self-adhesive gasket, then stick
5. Screw the two fixing studs into the threaded sockets on the rear of
6. Pass the SeaTalk/NMEA cables through the bulkhead and
7. Place the assembled control unit, studs and gasket into the panel.
8. Locate the bracket onto the fixing studs and secure the assembly
ST6001+ Autopilot Control Unit - Owner's Handbook
1
3
(
/
in) and 20 mm (
/
8
handbook) to the selected location. Mark the aperture into which
the control unit will sit, then remove the template.
the gasket into position on the rear of the control unit.
the control unit.
connect them to the appropriate terminals (as described later in
this chapter).
to the panel with the thumb-nuts. Hand-tighten the thumb nuts –
do NOT use a wrench.
Aperture
cut-out
in) thick.
4
Self-adhesive
Fixing
gasket
stud
Bracket
Thumb
screw
D4585-2