Data Pages - Raymarine autopilot Owner's Handbook Manual

Chapter 7: Adjusting Autopilot Settings

Data pages 1-7

The next 7 screens allow you to modify the settings for the data pages.
These define the SeaTalk/NMEA data pages that will be available
during normal operation (see page 29). Each data page setup screen
initially shows the title DATA PAGE and the page number. After 1
second, the text changes to the title of the data currently set for that
page.
The default settings are:
Data page
1
2
3
4
5 -7
*Note: It is good practice to keep the BTW and DTW pages for display. If the
autopilot receives a man overboard (MOB) message, these data pages will
show the bearing and distance to the MOB location.
To change the data displayed on a data page:
•
•
•
Available data pages
Speed Knots
Log
Trip
Average Speed, Knots
Wind Direction
Wind Speed
Depth Metres*
Depth Feet*
Depth Fathoms*
Default setting
XTE (Cross Track Error)
BTW* (Bearing to Waypoint)
DTW* (Distance to Waypoint)
RESPONSE
NOT USED (These pages are not displayed when you scroll
through the data pages during normal operation)
Press disp to move to the appropriate data page setup screen.
Use the -1 and +1 keys to scroll forwards or backwards through
the available data pages (see following table).
Then press disp to move to the next data page you want to
change, or press and hold standby for 2 seconds to save changes.
Displayed as
SPEED KTS
LOG XXXX.X
TRIP XXX.X
AV. SPD KTS
e.g. WIND PORT
WIND KTS
DEPTH M
DEPTH FT
DEPTH FA
81