Chapter 7: Adjusting Autopilot Settings - Raymarine autopilot Owner's Handbook Manual

Chapter 7: Adjusting Autopilot Settings

Chapter 7: Adjusting Autopilot Settings
This chapter explains all of the calibration settings you can adjust on
the autopilot system. You will have adjusted many of these settings
when commissioning the system (see Chapter 6), and they should not
require further adjustment.
Note: Complete the procedures described in Chapter 6 before
adjusting any calibration settings.
The sections in this chapter provide explain the Calibration mode and
the settings in the 4 calibration groupings:
7.1
7.2
7.3
7.4
7.5
Note: If you are connecting the ST6001+ to a non-150/400 autopilot
system, the calibration groups are different. Refer to the Appendix for
more information.
Calibration basics
This explains the structure of the Calibration mode, and
how to access the four calibration groupings.
Display Calibration
The Display Calibration grouping allows you to control
the ST6001+ display features (bar graph type and data
page information).
User Calibration
The User Calibration grouping includes autopilot
settings that you may need to adjust in response to
changing sea conditions.
Seatrial Calibration
The Seatrial Calibration grouping is used specifically for
the initial autopilot seatrial (see Chapter 6 for full
details).
Dealer Calibration
The Dealer Calibration grouping controls the main
autopilot settings and also the calibration lock.
75
page 76
page 79
page 83
page 87
page 88