HP Apollo 4200 Gen9 Maintenance And Service Manual page 31

Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 27).
3.
Remove the access panel
4.
If expansion boards with internal cabling are installed on the PCI riser cage, disconnect all internal
5.
cables from the expansion boards to completely remove the cage from the server.
Remove the PCI riser cage:
6.
Disconnect the power cable from the riser board.
a.
Loosen the captive screw on the front end of the PCI riser cage.
b.
Loosen the thumbscrew on the rear end of the PCI riser cage.
c.
Grasp the PCI riser cage at the touch points and lift it out of the chassis.
d.
("Access panel" on page 36).
DRAFT - HP Confidential - DRAFT
Removal and replacement procedures 31