Moving A Frequency From A Monitor Memory To A Channel; Scanning Channels - Radio Shack PRO-76 Owner's Manual

20-313.fm Page 26 Friday, January 7, 2000 3:09 PM
Moving a Frequency
from a Monitor
Memory to a Channel
Follow these steps to move
a frequency stored in a mon-
itor memory to a permanent
channel.
1. Press .
MANUAL
appears.
2. Enter the number (
) for the channel
200
where you want to store
the monitor frequency.
The channel number
appears.
3. Press . The cur-
PROG
rently stored frequency
appears.
4. Press then
MON
number of the monitor
memory number
has the frequency you
want to store. The chan-
nel number flashes.
5. Press . The scanner
E
stores the frequency in
the selected channel,
and the channel num-
ber stops flashing.
26
SCANNING
CHANNELS
Note: You
channels until you have
stored frequencies in them.
To scan channels stored in
the channel-storage banks,
MAN
press
SCAN
scans through all channels
1–
in the active banks.
To select one or more channel-
storage banks while scan-
ning, select each bank you
want to scan by pressing its
number key so the bank's
number appears on the dis-
play.
the
To turn off channel-storage
banks, press the number key
that
for each of the bank(s) so
the bank's number disap-
pears. The scanner does not
scan any of the stored chan-
nels within banks you have
turned off.
To set the scanner to remain
on the current channel even
after the transmission stops,
press
MANUAL
during the transmission.
cannot scan
. The scanner
at any time