Using The Monitor Memory; Listening To A Monitor Memory Frequency; Moving A Frequency From A Monitor Memory To A Channel; Scanning The Stored Channels - Radio Shack Desktop Scanner Owner's Manual

• If you entered a frequency that is
already stored in another channel,
dUPL- and the lowest-numbered
channel containing the duplicate
frequency flash for about 3 seconds.
If you want to store the frequency
anyway, press
ENTER
• To store the displayed frequency in
the selected channel, press
press the channel number you want
to use and press
press . The channel and
ENTER
frequency flash twice, and the
scanner stores the frequency. Then
the scanner continues to search for
frequencies.
4. To store the frequency in the monitor
memory, press
MON/CL
memory number, and the frequency
flash twice.
5. To search for another active frequency,
8 8 8 8 9 9 9 9
hold down or
USING THE MONITOR
MEMORY
The scanner has 20 monitor memories that
you can use to temporarily store frequencies
while you decide whether to save them into
channels. This is handy for quickly storing an
active frequency when you are searching
through an entire band. You can store a
frequency into a monitor memory during a
service bank or direct search.
You can select monitor memories manually,
but you cannot scan them. See "Listening to
a Monitor Memory Frequency."
Listening to a Monitor Memory
Frequency
To recall a frequency stored in the monitor
memory, press
MANUAL
monitor memory number, and
-
again.
,
PGM
again, then
PGM
. , the monitor
M
.
then . M , the
MON/CL
flash and
CH
Operation
the current monitor memory frequency
appears. To select other monitor memories,
enter the desired monitor memory's number
(1–20), then press
MON/CL
Moving a Frequency from a
Monitor Memory to a Channel
1. Press , enter the channel number
PGM
where you want to store the frequency,
then press again.
PGM
selected channel number appear.
2. Press . , a monitor memory
MON/CL M
number, and CH flash, and the monitor
memory frequency appear.
3. Enter the desired monitor memory's
number (1–20), then press
again. The selected monitor memory's
frequency appears.
4. Press . The scanner stores the
ENTER
frequency in the selected channel.
5. To move another monitor memory
frequency to the next channel, press
and repeat Steps 2–4.
PGM
SCANNING THE STORED
CHANNELS
To set the scanner to continuously scan
through all channels with stored frequencies,
and 8 appear, and the
press . SCAN
SCAN
scanner begins to rapidly scan until it finds
an active frequency.
If the scanner finds an active frequency, it
stops and displays that channel and
again.
PGM and the
MON/CL
17