Table of Contents
Advertisement
4. Pull the node out of the rack so the slides are fully extended.
5. Press the front slide release latches
6. Securely tighten the four mounting screws that you previously installed at the
7. Press the front slide release latches
8. Repeat this procedure for each SAN Volume Controller 2145-8G4 that needs to
Connecting the SAN Volume Controller 2145-8G4 to the 2145 UPS-1U
Before you connect the SAN Volume Controller 2145-8G4 node to the 2145
uninterruptible power supply-1U (2145 UPS-1U), review the restrictions that exist
between the two systems.
node into the rack cabinet and back out to verify that the node moves freely.
front and rear of both rails.
rack cabinet.
Attention: Use only the rear slide release latches
Volume Controller 2145-8G4 from the rack.
be installed.
Tip: If you have available space, leave a 1
improve the air circulation in the rack.
Chapter 6. Installing the SAN Volume Controller 2145-8G4 hardware
1
on both sides of the node and move the
1
and push the node all the way into the
2
to remove the SAN
space between each node to
53
Hide quick links:
Advertisement
Table of Contents
